The influence of spectrum and imaging geometry on propagation-based phase-contrast imaging for micro-focus source

In addition to the widely used monochromatic X-ray source, the polychromatic X-ray source may also be used in many cases of propagation-based phase-contrast imaging (PB-PCI). It is not sufficient to investigate the optimization procedure only for the monochromatic applications. The focus of this paper is to investigate the effects of spectrum and imaging geometry on the image quality of PB-PCI, for applications involving propagation in vacuum and air. The quality of phase contrast image has been quantitatively characterized by using contrast and SNR as quality metrics in this paper. The optimal geometry has been investigated in three situations, where four cases are considered. Based on the numerical simulation, it is observed that the contrast and SNR in the case of polychromatic X-ray are lower than the monochromatic X-ray. Therefore, the influence of the X-ray spectrum on the contrast and SNR must not be neglected. The contrast in the case of polychromatic X-ray, and the SNR in both polychromatic and monochromatic X-ray, is lower for propagation in air compared to the propagation in vacuum. Evidently, the air absorption is an important factor in the propagation-based phase-contrast imaging. The experimental and numerical results for all three situations are presented to verify the effect of the geometry on the image quality in the air condition. It is found that the experimental results confirm the validity of numerical results for both the quality metrics. The object specification and the X-ray scattering have obvious influence on the image quality, as seen in the experimental results.