The effect of altered loading following rotator cuff tears in a rat model on the regional mechanical properties of the long head of the biceps tendon

Biceps tendon pathology is a common clinical problem often seen in conjunction with rotator cuff tears. A previous study found detrimental changes to biceps tendons in the presence of rotator cuff tears in a rat model. Therefore, the objective of this study was to utilize this model along with models of altered loading to investigate the effect of altered loading on the initiation of these detrimental changes. We created supraspinatus and infraspinatus rotator cuff tears in the rat and followed these tears with either increased or decreased loading. Mechanical properties were determined along the length of the biceps tendon 4 and 8 weeks following injury. At the insertion site, stiffness increased with decreased loading, while detrimental changes were seen with increased loading 4 weeks following detachments. Increased loading resulted in decreased mechanical properties along the entire tendon length at both time points. Decreased loading resulted in both increased and decreased tendon properties at different regions of the tendon at 4 weeks, but by 8 weeks, there were no differences between decreased loading and detachment alone. We could not conclude where changes begin in the tendon with altered loading, but did demonstrate that regional differences exist. These results support that there is an effect of altered loading, as decreased loading resulted in variable changes at 4 weeks that were no different from detachment alone by 8 weeks, and increased loading resulted in detrimental properties along the entire length at both 4 and 8 weeks.