Microscopic observation of cold-deformed Al-4Cu-Mg alloy samples after semi-solid heat treatments

Wrought aluminum alloys can be effectively fabricated by a strain-induced, melt-activated (SIMA) process. The SIMA method involves plastic deformation of an alloy to some critical reduction point and a semi-solid heat treatment in the solid-liquid temperature range. The semi-solid heat treatment is a key process to control the semisolid microstructures. In this paper, the microscopic morphology of a cold-deformed SIMA treated Al-4Cu-Mg alloy has been investigated, and the effects of microstructural evolution, precipitation behavior and dislocation morphology on the mechanical properties are discussed. The experimental results show that the number of CuAl2 (θ phase) precipitates and the dislocation density of Al-4Cu-Mg alloy decreased gradually by the semi-solid heat treatment. Moreover, unique dislocation morphologies including helical dislocations and dislocation loops appeared and evolved to reduce the stored energy. With an increase of the holding time in the semi-solid heat treatment, the ultimate strength and yield strength decreased. The reduction of these mechanical properties of the SIMA treated Al-4Cu-Mg alloy is mainly due to the decrease of refinement strengthening, solution strengthening, and dislocation strengthening in the semi-solid heat treatment.