Keywords: نرخ سخت شدن تنش; Twinning-induced plasticity steel; Voids; Necking; Strain-hardening rate;
مقالات ISI نرخ سخت شدن تنش (ترجمه نشده)
مقالات زیر هنوز به فارسی ترجمه نشده اند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
Deformation mechanisms of Al0.1CoCrFeNi high entropy alloy at ambient and cryogenic temperatures
Keywords: نرخ سخت شدن تنش; High entropy alloys; Deformation mechanism; Strain-hardening rate; Serration phenomena; Nano-twinnings;
Effects of Al on microstructure and tensile properties of C-bearing high Mn TWIP steel
Keywords: نرخ سخت شدن تنش; Twinning; Stacking-fault energy; Strain-hardening rate; Dynamic strain aging; Strain-rate sensitivity
Nanocrystalline metals go ductile under shear deformation
Keywords: نرخ سخت شدن تنش; Shear deformation; Activation volume; Strain-hardening rate; Nanocrystalline metals; Plasticity
Comparative study on mechanical behavior of low temperature application materials for ships and offshore structures: Part I-Experimental investigations
Keywords: نرخ سخت شدن تنش; Cryogenic tensile test; Austenitic stainless steel; Aluminum alloy; Nickel steel alloy; Strain-hardening rate; Strain rate sensitivity;
Mechanical properties and strain-hardening behavior of Mg alloy AZ31B-H24 thin sheet
Keywords: نرخ سخت شدن تنش; AZ31B Mg alloy; Strain-hardening; Strain-hardening rate; Dynamic recrystallization;
Tensile flow and strain-hardening behaviors of dual-phase Mg-Li-Zn alloy thin sheets
Keywords: نرخ سخت شدن تنش; Magnesium-lithium alloy; Tensile flow behavior; Strain-hardening; Strain-hardening rate;
Deformation in metals after low-temperature irradiation: Part II - Irradiation hardening, strain hardening, and stress ratios
Keywords: نرخ سخت شدن تنش; Irradiated metals; Irradiation-hardening rate; Strain-hardening rate; Plastic instability stress; Fracture stress;