Confined impinging twin air jets at high Reynolds numbers

An experimental study is carried out to investigate flow characteristics of confined twin jets issuing from the lower surface and impinging normally on the upper surface. Pressure distributions on the impingement and confinement plates were obtained for Reynolds numbers ranging from 30,000 to 50,000, nozzle-to-plate spacing (H/D) in the range of 0.5-4 and jet-to-jet spacing (L/D) in the range of 0.5-2. Smoke-wire technique was used to visualize the flow behavior. The effects of Reynolds number, nozzle-to-plate spacing and jet-to-jet spacing on the flow structure are examined. The subatmospheric regions occur on both impingement and confinement plates at the nozzle-to-plate spacing up to 1 for all studied Reynolds numbers and jet-to-jet spacings in consideration. They lie nearly up to the same radial location at both surfaces and move radially outward from the stagnation points with increasing nozzle-to-plate spacing and jet-to-jet spacing. It is concluded that there exists a relation between the subatmospheric regions and peaks in heat transfer coefficients for low spacings in the impinging jets.