Simultaneous extraction of source and drain resistances in top contact organic thin film transistors from a single test structure

A method of extraction of source and drain resistances in linear mode of operation from a single transistor is described. The proposed method can also be used to measure source resistance over the entire operating range from linear to saturation mode of operation. The method uses two floating probes outside the channel, one adjacent to the source and the other to the drain to sense the voltage under these contacts. Using transmission line analysis, the source and drain resistances are directly extracted from these measurements. 2D numerical simulation results confirm the validity of the proposed technique and sensitivity analysis shows that the method is more accurate than the conventional gated four probe technique, especially, when the source resistance is much smaller than the channel resistance. Experimental results obtained with Pentacene top-contact transistors are used to illustrate the proposed technique. Analysis of two devices with very different source resistance is carried out to highlight the ability of the proposed technique to offer insight into the different contributing factors. Current crowding under the source contact and accurate estimation of mobility without the distorting effects of source resistance are also described.

Figure optionsDownload as PowerPoint slideHighlights
► We presented source and drain resistances extraction procedure from a single test structure.
► Sensitivity analysis shows that the method is more accurate than the conventional gated four probe technique.
► Current crowding under the source contact and accurate estimation of mobility without the distorting effects are described.