کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
1287014 973209 2006 5 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Development of a miniaturized polymer electrolyte membrane fuel cell with silicon separators
موضوعات مرتبط
مهندسی و علوم پایه شیمی الکتروشیمی
پیش نمایش صفحه اول مقاله
Development of a miniaturized polymer electrolyte membrane fuel cell with silicon separators
چکیده انگلیسی

The fabrication process and electrochemical characterization of a miniaturized PEM fuel cell with silicon separators were investigated. Silicon separators were fabricated with silicon fabrication technologies such as by photolithography, anisotropic wet etching, anodic bonding and physical vapor deposition (PVD). A 400 μm × 230 μm flow channel was made with KOH wet etching on the front side of a silicon separator, and then a 550 nm gold current collector and 350 nm TiNx thin film heater were respectively formed on the front side and the opposite side by PVD. Two separators were assembled with the membrane electrode assembly (MEA) having a 4 cm2 active area for the single cell. With pure hydrogen and oxygen under atmospheric pressure without humidification, the performance of the single fuel cell was measured. A single cell operation led to generation of 203 mW cm−2 at 0.6 V at room temperature, which corresponded to 360 mW cm−3 in terms of volumetric fuel cell power density, with 20 ccm of gas flow rate of hydrogen and oxygen at the inlet.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Power Sources - Volume 161, Issue 1, 20 October 2006, Pages 432–436
نویسندگان
, , , , ,