کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1287153 | 1498039 | 2006 | 10 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Investigation of thermal and electrochemical degradation of fuel cell catalysts Investigation of thermal and electrochemical degradation of fuel cell catalysts](/preview/png/1287153.png)
A significant problem hindering large-scale implementation of proton exchange membrane (PEM) fuel cell technology is the loss of performance during extended operation and automotive cycling. Recent investigations of the deterioration of cell performance have revealed that a considerable part of the performance loss is due to the degradation of the electrocatalyst. In this study, an attempt is made to experimentally simulate the degradation processes such as carbon corrosion and platinum (Pt) surface area loss using an accelerated thermal sintering protocol. Two types of Tanaka fuel cell catalyst samples were heat-treated at 250 °C in humidified helium (He) gas streams and several oxygen (O2) concentrations. The catalysts were then cycled electrochemically in pellet electrodes to determine the hydrogen adsorption (HAD) area and its evolution in subsequent electrochemical cycling. Samples that had undergone different degrees of carbon corrosion and Pt sintering were characterized for changes in carbon mass, active Pt surface area, BET (Brunauer, Emmett and Teller) surface area, and Pt crystallite size. Studies of the effect of oxygen and water concentration on two Tanaka catalysts, dispersed on carbon supports with varying BET areas, revealed that carbon oxidation in the presence of Pt follows two pathways: an oxygen pathway that leads to mass loss due to formation of gaseous products, and a water pathway that results in mass gains, especially for high BET area supports. These processes may be assisted by the formation of highly reactive OH and OOH type radicals. Platinum surface area loss, measured at varying oxygen concentrations and as a function of sintering time using X-ray diffraction (XRD), CO chemisorption, and electrochemical hydrogen adsorption, reveal an important role for carbon corrosion rather than an increase in Pt particle size for the surface area loss. Platinum surface area loss during 10 h of thermal degradation was equivalent to electrochemical degradation observed over 500 cycles for a Tanaka Pt/Vulcan electrode cycled between 0 and 1.2 V (normal hydrogen electrode-NHE). Carbon mass loss observed for 5 h of thermal degradation was comparable to that obtained during a potential hold for 86 h at 1.2 V (NHE) and 95 °C for the same catalysts.
Journal: Journal of Power Sources - Volume 160, Issue 2, 6 October 2006, Pages 977–986