کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1290442 | 973325 | 2008 | 6 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Electrochemical oxidation behavior of Mg–Li–Al–Ce–Zn and Mg–Li–Al–Ce–Zn–Mn in sodium chloride solution Electrochemical oxidation behavior of Mg–Li–Al–Ce–Zn and Mg–Li–Al–Ce–Zn–Mn in sodium chloride solution](/preview/png/1290442.png)
Mg–Li–Al–Ce–Zn and Mg–Li–Al–Ce–Zn–Mn alloys were prepared using a vacuum induction melting method. Their electrochemical oxidation behavior in 0.7 M NaCl solution was investigated by means of potentiodynamic polarization, potentiostatic oxidation, electrochemical impedance technique and scanning electron microscopy examination. Their utilization efficiencies and performances as anode of metal–hydrogen peroxide semi-fuel cell were determined. The Mg–Li–Al–Ce–Zn–Mn exhibited higher discharge activity and utilization efficiency than Mg–Li–Al–Ce–Zn, and gave improved fuel cell performance. The utilization efficiency of Mg–Li–Al–Ce–Zn–Mn is comparable with that of the state-of-the-art magnesium alloy anode AP65. The magnesium–hydrogen peroxide semi-fuel cell with Mg–Li–Al–Ce–Zn–Mn anode presented a maximum power density of 91 mW cm−2 at room temperature. Scanning electron microscopy and electrochemical impedance studies indicated that the alloying element Mn prevented the formation of dense oxide film on the alloy surface and facilitated peeling off of the oxidation products.
Journal: Journal of Power Sources - Volume 183, Issue 2, 1 September 2008, Pages 799–804