Porous mullite blocks with compositions containing kaolin and alumina waste

In the production of alumina by the Bayer process, the calcination step generates a waste containing ~90% aluminum oxide (Al2O3). Due to the high content of this oxide, this waste can be used as a source of alumina in porcelain formulations, especially those used in the synthesis of mullite. The purpose of this study was to produce porous mullite blocks using compositions containing kaolin and alumina waste. The compositions were formulated based on a mullite stoichiometry of 3:2. Heat treatments were carried out in a conventional furnace at temperatures of 1450 to 1500 °C, applying a heating rate of 5 °C/min and a 1-h hold time at the firing temperature threshold. The powders were characterized by means of X-ray fluorescence (XRF); X-ray diffraction (XRD); thermal analysis (TGA-DTA); scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The physic mechanical properties of the test specimens: water absorption, apparent porosity, linear shrinkage and flexural strength were also evaluated. The XRD results revealed the formation of mullite as the major phase. The morphological analysis by SEM revealed typical mullite needles originating from clay minerals. The size of the mullite needles was calculated based on the TEM analysis, which indicated diameters smaller than 400 nm, confirming the nanometric dimensions of the needles. The flexural strength test of the specimens indicated that this parameter ​​tends to increase as the temperature is raised.