Visible light catalysis of methyl orange using nanostructured WO3 thin films

WO3 thin films have been deposited onto glass and FTO coated glass substrates using a simple chemical spray pyrolysis technique. The structural, morphological, optical and photocatalytic properties of WO3 thin films are studied. The photoelectrochemical (PEC) study shows that, both short circuit current (Isc) and open circuit voltage (Voc) are (Isc=0.38 mA and Voc=0.59 V) relatively higher at 300 °C substrate temperature. The structure and morphology of WO3 thin films are studied by X-ray diffraction (XRD), scanning electron microscopy (SEM) and atomic force microscopy (AFM). XRD study reveals that the films are polycrystalline in nature with monoclinic crystal structure. SEM images show that the substrate surface is covered with a uniform and grain like morphology. The AFM images show the rough nature of the film. The structure and local symmetry of the film are studied with the help Raman spectroscopy. The chief vibrational modes of the WO3 sample, located at 805, 715 and 269 cm−1 corresponding to the stretching and the bending of O–W–O bond respectively and are consistent with a monoclinic structure and the low-frequency peaks are observed at 269 and 325 cm−1 can be assigned due to the bending δ (O\W\O) vibrations in monoclinic structure. Photoelectrocatalytic degradation of methyl orange (MO) dye in aqueous solutions is studied. The end result shows that the degradation percentage of methyl orange (MO) using WO3 photoelectrode has reached 98% under visible light illumination after 320 min. The amount of degradation is confirmed by COD and TOC analysis.