Cleaner production of porcelain tile powders. Fired compact properties

A new ceramic powder preparation process, the droplet-powder granulation process (DPGP), was recently proposed for the cleaner production of ceramic tiles. The DPGP granules and resulting pressed compacts were characterized and compared with the granules and compacts obtained by spray-drying (SD) and dry granulation (G) processes in a previous paper. The results showed the feasibility of using the DPGP in the pre-firing stage of porcelain tile manufacture.This study compares the firing behaviour and fired properties of compacts pressed from three different types of granulated powders: DPGP, SD, and G and from a non-granulated powder (NG) obtained by dry milling. The evolution of compact microstructure (porosity and pore size distribution) with firing temperature was monitored and the fired compact properties (bulk density, water absorption, and stain resistance) were determined.The study shows that the DPGP improved the sintering behaviour and final properties of the resulting porcelain tiles with respect to those obtained by the G process. However, the fired compacts prepared from the DPGP powder exhibited a higher porosity and pore size compared with those of the compacts obtained from the SD granules at the same pressing pressure. The results obtained open up the possibility of manufacturing glazed porcelain tiles with a more eco-friendly process. However, the results also indicate that polished porcelain tile manufacture by the DPGP requires further research in order to improve granule characteristics, in particular green granule deformability, which is the critical factor in porcelain tile densification and vitrification during firing.