Fabrication and characterization of composite sol–gel coatings on porous ceramic substrate

Highly porous ceramic materials were coated using a composite sol–gel method. Alumina powder is dispersed in a silica sol–gel solution and then dip-coated on the substrate. The resulting coatings present a composite microstructure in which crystalline alumina grains are linked to each other by an amorphous silica phase. In this work, we show that, by accurately controlling the sol–gel parameters (water, solvent and silica precursor (TEOS) ratio, pH and ageing time of the sol) and also the powder grain size distribution it is possible to obtain crack-free thick films (more than 20 μm in one step). These coatings present good adherence to the substrate, decrease the roughness and also close the surface porosity of the substrate. Coating mechanical properties have been evaluated thanks to micro-indentation measurements and linked to coating structural evolution with the thermal treatment temperature.