Bulk TiCxN1−x–15%Co cermets obtained by direct spark plasma sintering of mechanochemical synthesized powders

TiCxN1−x–15 wt.%Co cermets were obtained by a mechanically induced self-sustaining reaction (MSR) and sintered by spark plasma sintering (SPS) technique at different temperatures (1200–1400 °C) for 1 min in vacuum under a uniaxial load of 80 MPa. The evolution of microstructure and mechanical properties was investigated. SPS allowed high densification with limited grain growth at a relatively low temperature. Material sintered at 1300 °C showed a good combination of mechanical properties with Vickers hardness of 17.1 ± 0.5 GPa, fracture toughness of 5.51 ± 0.29 MPa m1/2 and bending strength of 904 ± 12 MPa. Lower sintering temperature resulted in a decrease in bending strength due to poor cohesion between the ceramic and binder phases. An increase in sintering temperature would allow tailoring the cermet microstructure and, therefore, adjusting the Vickers hardness/fracture toughness relation.

Figure optionsDownload as PowerPoint slideHighlights
► TiCN–15%Co was obtained by mechanically induced self-sustaining reaction and SPS.
► Superior mechanical properties with homogeneous microstructure were developed.
► Cermet sintered at 1300 °C achieved high density 99% and bending strength 904 MPa.