Improvement of SiCf/SiC density by slurry infiltration and tape stacking

SiC fiber-reinforced SiC–matrix ceramic composites (SiCf/SiC) were fabricated by vacuum infiltration of a SiC slurry into Tyranno™-SA grade-3 fabrics coated with a 200 nm-thick pyrolytic carbon (PyC) layer followed by hot pressing using a transient eutectic-phase. The density of the composite was improved using a special infiltration apparatus with a pressure gradient and alternating tape insertion between fabrics. Their overall properties were compared with those of monolithic SiC and composite containing chopped fibers. Although the density of the composites decreased with increasing fiber fraction, SiCf/SiC containing 50 vol.% fibers had a density of 3.13 g/cm3, which is the highest reported thus far. The composites containing continuous fibers had a maximum flexural strength of 607 MPa and a step increase in the stress–displacement behavior during the three-point bending test due to fiber reinforcement, which was not observed in the monolith.