Dependence of Seebeck coefficient on a load resistance and energy conversion efficiency in a thermoelectric composite

The thermo-emf ΔV and current ΔI generated by imposing the alternating temperature gradients (ATG) at a period of T and the steady temperature gradient (STG) on a thermoelectric (TE) composite were measured as a function of t, where t is the lapsed time and T was varied from 60 to or ∞ s. The STG and ATG were produced by imposing steadily and alternatively a source voltage V in the range from 1.0 to 4.0 V on two Peltier modules sandwiching a composite. ΔT, ΔV, ΔI and VP oscillate at a period T and their waveforms vary significantly with a change of T, where ΔV and VP are the voltage drops in a load resistance RL and in resistance RP of two modules. The resultant Seebeck coefficient |α| = |ΔV|/ΔT of a composite under the STG was found to be expressed as |α| = |α0|(1 − Rcomp/RT), where RT is the total resistance of a circuit for measuring the output signals and Rcomp is the resistance of a composite. The effective generating power ΔWeff has a local maximum at T = 960 s for the p-type composite and at T = 480 s for the n-type one. The maximum energy conversion efficiency η of the p- and n-type composites under the ATG produced by imposing a voltage of 4.0 V at an optimum period were 0.22 and 0.23% at ΔTeff = 50 K, respectively, which are 42 and 43% higher than those at ΔT = 42 K under the STG. These maximum η for a TE composite sandwiched between two Peltier modules, were found to be expressed theoretically in terms of RP, RT, RL, αP and α, where αP and α are the resultant Seebeck coefficients of Peltier modules and a TE composite.