The fabrication of front electrodes of Si solar cell by dispensing printing

The dispensing printing was applied to fabricate the front electrodes of silicon solar cell. In this method, a micro channel nozzle and normal Ag paste were employed. The aspect ratio and line width of electrodes could be controlled by the process variables such as the inner diameter of nozzle, dispensing speed, discharge pressure, and the gap between wafer and nozzle. For the nozzle with the inner diameter of 50 μm, the line width and aspect ratio of electrode were under 90 μm and more than ∼0.2, respectively. When comparing the efficiency of solar cell prepared by conventional screen printing and the dispensing printing, the latter exhibited 19.1%, which is 0.8% absolute higher than the former even with the same Ag paste. This is because the electrode by dispensing printing has uniform aspect ratio and narrow line width over the length of electrode.

► We propose the process for the front silver electrode by employing dispensing method.
► The dispensing method is a non-contact printing process.
► The electrode by dispensing method has more uniform and narrower shape.
► The dispensing method helped to enhance the efficiency of solar cell by 0.8% absolute.