A modification on ECAP process by incorporating torsional deformation

In the present study, integration of equal channel angular pressing (ECAP), as a well known severe plastic deformation (SPD) technique, and torsion deformation, is studied by using three dimensional finite element analysis. This process is to be named as torsional-equal channel angular pressing (T-ECAP). In this modification a part of the exit channel in the ECAP die is rotating around its axis, to impose extra shear strains to the samples. To study deformation behavior in the T-ECAP process, three-dimensional finite element analysis (FEA) was carried out by using the elasto-plastic finite element analysis ABAQUS/Explicit Simulation. To investigate the validity of the simulation results, experimental studies were furthermore performed on commercially pure aluminum (AA 1050). Vickers hardness test was used to determine the distribution of hardness on both normal and longitudinal sections of the deformed samples with respect to the exit channel of the die. The hardness test results showed more uniform distribution of hardness in both sections of the T-ECAP processed samples regarding the ones produced by ECAP process. The load requirement comparison for performing both processes showed lower value for the T-ECAP with respect to the ECAP process. The simulation results for the strain values showed higher magnitude and more uniform distribution for the T-ECAP with respect to the ECAP process.

Research highlights
► T-ECAP process is introduced as a modified SPD technique using 3-D finite element analysis.
► Process load is lower in T-ECAP process in comparison to ECAP process.
► T-ECAP process shows more uniform strain distribution in comparison to ECAP process.
► Higher amount of strain is imposed to the sample during each pass in T-ECAP process.
► The exit channel rotation is diffused to the samples’ center.