Nickel (II) ions sensing properties of dimethylglyoxime/poly(caprolactone) electrospun fibers

A novel dimethylglyoxime (DMG)/poly(caprolactone) (PCL) blend was electrospun into fibers to serve as an optical sensor for the nickel detection based on the formation of a red Ni(DMG)2 complex. DMG was mixed with PCL at 10, 20 and 30% (w/w) in a mixture of N, N-dimethylformamide (DMF) and dichloromethane (DCM) (50/50, v/v) prior electrospunning process. The best fibers were prepared under an electric field of 20 kV and a distance between needle and collector of 20 cm. From scanning electron microscopy (SEM), the average diameter of the fibers remained nearly constant with increasing amount of DMG. The optimum mass ratio of DMG and PCL was found to be 20:80 as it produced fibers with the smallest diameter distribution and the best sensing property. The formation of the Ni(DMG)2 complex was confirmed by Fourier transform infrared spectroscopy (FT-IR). The colorimetric response of the PCL/DMG electrospun fibers were then tested against the nickel ions over a concentration range of 1–10 ppm using reflectance spectroscopy. Good linearity between the reflectance values at 547 nm and the concentrations was obtained (R2 = 0.9925). These proposed DMG and PCL fibers could be used as the naked-eye sensor for nickel in waste water.