Tribology and cyclic oxidation behavior of plasma nitrided valve steel

In this study, the tribology and cyclic oxidation behavior of plasma nitrided DIN 1.4871 austenitic valve steel were investigated. For this purpose plasma nitriding treatments were carried out in nitrogen and hydrogen with ratio N2/H2: 1/3 at 10 Torr pressure. Nitriding cycles of 400, 450, 500 and 550 °C for 7 h were selected. To remove oxide layer and to enhance diffusion, an effective sputter cleaning procedure was applied in argon and hydrogen gases. The pin-on-disc sliding wear experiments were performed at a load of 6 N and sliding velocity of 0.1 m/s in normal atmosphere under dry condition. Cyclic oxidation tests used to evaluate the oxidation characteristics of the samples consisted of 50 cycles each 30 min at 750 °C. The structure and properties of the samples were examined by optical and scanning electron microscopy (SEM), microhardness measurements and X-ray diffraction. The results indicated plasma nitriding at all temperatures increased the wear resistance of valve steel when sliding against bearing steel. The 550 °C nitrided layer, with CrN, Fe4N and Fe2-3N on the surface, was most effective in improving wear resistance. In the case of cyclic oxidation, the results showed that oxidation resistance depends strongly on nitriding temperature. Nitriding at 450 °C produced a layer of predominantly “S” phase which was more effective in improving the oxidation resistance of valve steel.