Dosimetric evaluation of an indigenously developed 10 MeV industrial electron beam irradiator

The high dose rate electron beams are increasingly being used for radiation processing of various products worldwide. A comprehensive dosimetric evaluation of an in-house developed 10 MeV industrial electron beam irradiator was carried out in static as well as in dynamic mode of irradiations. Radiochromic B3 film and graphite calorimeter were used for dosimetric measurements. The dose rate from the electron beam was also calculated using the empirical relation prescribed in the ASTM report E2232-02. The measured electron beam profile indicates the dose rate variation within 8% in the irradiated product boxes. The most probable energy determined from the depth dose distribution in PMMA, Al and water was found in agreement with the intended energy of the electron beam. Measured dose rate using radiochromic film and graphite calorimeter were found in good agreement with each other and also found comparable with the theoretically estimated dose rates. Experimentally measured dose rates were considered for the trial irradiation of medical and industrial products. Dosimetric data obtained through this study confirms the suitability of the irradiator for routine radiation processing of various products.

► Dosimetry of in-house developed industrial 10 MeV electron accelerator irradiator.
► Radiochromic film and calorimeter are used to evaluate dosimetric parameters.
► Dose rate measurement in static and dynamic operation conditions of the irradiator.
► Verification of electron beam energy by depth dose and practical range measurement.
► Trial irradiation of simulated medical and industrial products.