کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
205395 461107 2016 9 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Experimental analysis on spray development of 2-methylfuran–gasoline blends using multi-hole DI injector
ترجمه فارسی عنوان
تجزیه و تحلیل تجربی در توسعه اسپری 2-متیل بوران بنزین مخلوط با استفاده از چند انفجار انژکتور
کلمات کلیدی
ساختارهای اسپری، جوش فلزی، 2-متیل فوران بنزین، چند انژکتور
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی مهندسی شیمی (عمومی)
چکیده انگلیسی


• Two different spray patterns can be observed from experiment images.
• Flash boiling intensifies with the increase of MF mixing ratio.
• The spray cone angle with MF is increased at lower and higher pressures.
• Spray penetration decreases with increase of MF mixing ratio at high pressures.
• Spray area has a negative correlation with fuel temperature at low pressures.

Confronting the situation of environment pollution and energy shortage, direct injection (DI) system has been commonly used in gasoline engines for its good performance in fuel economy, combustion efficiency, emissions and cold-start. Currently, 2-methylfuran (MF) has already been a more attractive biomass fuel in spark ignition (SI) engine, however, there is little knowledge about its spray behaviors in DI injector, especially when it is used as a gasoline additive. In this study, the spray characteristics of MF–gasoline blends M20 (20% volume fraction MF–gasoline blend fuel), M40 and pure gasoline from 6-hole DI injector are investigated under various ambient pressures and fuel temperatures using high-speed schlieren photography. The experimental results show that two different spray shapes, flash boiling and non-flash boiling, can be observed from experiment images. When flash boiling occurs at low ambient pressure, the level of flash boiling intensifies with the increase of MF mixing ratio which can make spray front collapse intensely. The spray area increases with the MF mixing ratio rising and it has a negative correlation with the fuel temperature at low ambient pressures. As for no flash boiling case, the spray penetration decreases with the increase of MF mixing ratio. Under the ambient pressure of 0.6 MPa and 0.85 MPa, the spray cone angle for same fuel increases with the increase in fuel temperature. On the other hand, at the same fuel temperature, spray area increases slightly with the increase of mixing ratio of MF blended in gasoline.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Fuel - Volume 164, 15 January 2016, Pages 245–253
نویسندگان
, , , , , ,