Homogeneous charge compression ignition of LPG and gasoline using variable valve timing in an engine

The combustion characteristics and exhaust emissions in an engine were investigated under homogeneous charge compression ignition (HCCI) operation fueled with liquefied petroleum gas (LPG) and gasoline with regard to variable valve timing (VVT) and the addition of di-methyl ether (DME). LPG is a low carbon, high octane number fuel. These two features lead to lower carbon dioxide (CO2) emission and later combustion in an LPG HCCI engine as compared to a gasoline HCCI engine. To investigate the advantages and disadvantages of the LPG HCCI engine, experimental results for the LPG HCCI engine are compared with those for the gasoline HCCI engine. LPG was injected at an intake port as the main fuel in a liquid phase using a liquefied injection system, while a small amount of DME was also injected directly into the cylinder during the intake stroke as an ignition promoter. Different intake valve timings and fuel injection amount were tested in order to identify their effects on exhaust emissions and combustion characteristics. Combustion pressure, heat release rate, and indicated mean effective pressure (IMEP) were investigated to characterize the combustion performance. The optimal intake valve open (IVO) timing for the maximum IMEP was retarded as the λTOTAL was decreased. The start of combustion was affected by the IVO timing and the mixture strength (λTOTAL) due to the volumetric efficiency and latent heat of vaporization. At rich operating conditions, the θ90–20 of the LPG HCCI engine was longer than that of the gasoline HCCI engine. Hydrocarbon (HC) and carbon monoxide (CO) emissions were increased as the IVO timing was retarded. However, CO2 was decreased as the IVO timing was retarded. CO2 emission of the LPG HCCI engine was lower than that of the gasoline HCCI engine. However, CO and HC emissions of the LPG HCCI engine were higher than those of the gasoline HCCI engine.