Solid lipid extrusion of sustained release dosage forms

The applicability of the solid lipid extrusion process as preparations method for sustained release dosage forms was investigated in this study. Two lipids with similar melting ranges but of different composition, glyceryl palmitostearate (Precirol ATO 5®) and glyceryl trimyristate (Dynasan 114®), and mixtures of each lipid with 50% or 75% theophylline were extruded at temperatures below their melting ranges. Extrudates were analyzed using differential scanning calorimetry, scanning electron microscopy, porosity measurements and in vitro drug dissolution studies. The possibility of processing lipids by softening instead of complete melting and without subsequent formation of low-melting, metastable polymorphs could be demonstrated. Extrudates based on formulations of glyceryl palmitostearate/theophylline (50:50) and glyceryl trimyristate/theophylline (50:50) showed sustained release properties.An influence of extrusion conditions on the matrix structure was shown for extrudates based on a mixture of glyceryl trimyristate and theophylline (50:50). Glyceryl trimyristate tended to solidify in porous structures after melting. Exceeding a material temperature of 50.5 °C led to porous extrudate matrices with a faster drug release. The production of novel, non porous sustained release matrices was possible at a material temperature of 49.5 °C. Extrudates based on glyceryl trimyristate/theophylline (50:50) only slight changes in melting enthalpy and stable drug release profiles.