کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
228561 | 464843 | 2015 | 8 صفحه PDF | دانلود رایگان |
Modified aluminum alkoxide prepared by alcoholysis was used as an aluminum source in the complete liquid-phase technology for the preparation of slurry catalysts. The use of the modified aluminum alkoxide afforded control over the rate of the hydrolysis/condensation reactions during the preparation of the catalyst precursors, thereby generating catalysts with a fine nano-structured active metal and metallic oxide particles. Four types of Cu–Zn–Al (molar ratio is 2:1:4) catalysts were prepared using different procedures. These catalysts were tested for CO hydrogenation at 553 K, 4.0 MPa and H2/CO = 1.0 in a kettle with a mechanical agitator. The results indicated that the activity of the catalysts was greatly dependent on the rate of the hydrolysis/condensation reactions, and the catalyst with the best catalytic performance was obtained by controlling the hydrolysis/alcoholysis rate during catalyst synthesis by pre-alcoholysis of AIP as the aluminum source, over which the CO conversion and dimethyl ether selectivity could reach 62.6% and 62.5%, respectively.
Journal: Journal of Industrial and Engineering Chemistry - Volume 26, 25 June 2015, Pages 243–250