A revised design approach of the attachment system for the ITER EU-HCPB-TBM based on a central cylindrical connection element

The EU-Helium Cooled Pebble Bed Test Blanket Module (HCPB-TBM), which is located inside an equatorial port plug, is attached to the shield by an attachment system. The design of the attachment system has to fulfill two conflicting requirements. On the one hand, it has to transfer the high electromagnetic forces acting on the TBM to the shield and on the other hand, it has to compensate the different thermal expansions between the shield and the back plate of the TBM. The recent design approach of the attachment system consists of a hollow cylinder located at the center of the back plate. This design combines two advantages: a simple geometry and correspondingly low fabrication effort and the central location where the differential strain between back plate and shield is minimal. Static and transient thermal-structural analyses of the most demanding load cases, a fast vertical displacement event type II and the operation state tritium outgassing, have been performed to evaluate the design and confirm the compliance with the relevant design codes. A welded connection of the attachment system to the TBM back plate and a bolted connection in combination with a splined shaft is proposed for the shield side because of the dissimilar materials.

► Design of an attachment system based on a cylinder to connect TBM and shield.
► Attachment system has to cope with high EM loads and different thermal expansions.
► Stiff design and central position fulfill these requirements.
► Transient thermal-structural analyses confirm compliance of design with design codes.