کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
273165 | 505039 | 2009 | 4 صفحه PDF | دانلود رایگان |

The liquid lithium divertor (LLD) to be installed in NSTX has four toroidal panels, each a conical section inclined at 22° like the previous graphite divertor tiles. Each LLD panel is a copper plate clad with ∼0.25 mm of stainless steel (SS) and a surface layer of flame sprayed molybdenum (Mo) that will host lithium deposited from an evaporator. LITER (evaporators) already used in NSTX will be upgraded for the LLD. Each has twelve 500 W cartridge heaters with thermocouples, 16 other thermocouples, and a channel for helium cooling. During LLD experiments, the LLD will be heated so that the lithium is just above its melting temperature. The length of each shot will be preset to prevent excessive evaporation of lithium from the LLD. This duration depends on the heat load and is likely to be in the range of less than a second to several seconds. Careful thermal control of the LLD is important to maximize the shot times and to guide operation of the LLD. This paper describes the layout of the LLD, its expected thermal performance, the control system, and supporting experiments and analysis. A companion paper in this conference, “Physics design requirements for the national spherical torus experiment liquid lithium divertor,” provides other information.
Journal: Fusion Engineering and Design - Volume 84, Issues 7–11, June 2009, Pages 1438–1441