Degradation behaviour of HDPE geomembranes with high and low initial high-pressure oxidative induction time

The degradation of three high density polyethylene geomembranes (GMBs) (denoted xA, xB and xC) when immersed in simulated landfill leachate at 85 °C is examined. All three GMBs met the requirements of the generic industry specification GRI-GM13 with respect to their performance properties. The large high-pressure oxidative induction time (HP-OIT) (i.e., 790 min for xB and 960 min for xC) combined with the relatively high level of trace nitrogen detected, suggest the presence of hindered amine light stabilizers (HALS) as part of the antioxidant package in these GMBs, whereas, the relatively low initial HP-OITs (i.e., 260 min) and the low level of trace nitrogen for xA, suggest the absence of HALS in xA. Although xA had the lowest initial standard Std-OIT (Std-OIT was 115, 158 and 175 min for xA, xB and xC, respectively) it exhibited the longest time to antioxidant depletion based on Std-OIT. For the three GMBs, the HP-OIT depleted following exponential decay model until reaching a residual value. xB had the slowest HP-OIT depletion (0.016 month−1) and was still depleting without reaching a residual value at the end of this study (after 46 months). xA experienced the fastest HP-OIT depletion (∼62 times faster than of xB) and reached a residual value of 78 min. For xC, HP-OIT depleted 40 times faster than for xB reaching a residual value (∼610 min) that was still higher than the HP-OIT of 400 min specified by GRI-GM13 for a new GMB. xB had the longest time to nominal failure despite having the lowest initial SCR value (330 h for xB compared to 910 and 800 h for xA and xC, respectively) and not having the highest OITs values. Although xC had a residual HP-OIT of 610 min, the SCR, melt index (MI) and tensile properties for xC had decreased to the point that xC was at nominal failure, indicating that the degradation can take place without the total depletion of antioxidants/stabilizers captured by the HP-OIT.