Influence of temperature on a carbon–fibre epoxy composite subjected to static and fatigue loading under mode-I delamination

In this paper, interlaminar crack initiation and propagation under mode-I with static and fatigue loading of a composite material are experimentally assessed for different test temperatures. The material under study is made of a 3501-6 epoxy matrix reinforced with AS4 unidirectional carbon fibres, with a symmetric laminate configuration [0°]16/S. In the experimental programme, DCB specimens were tested under static and fatigue loading. Based on the results obtained from static tests, fatigue tests were programmed to analyse the mode-I fatigue behaviour, so the necessary number of cycles was calculated for initiation and propagation of the crack at the different temperatures. G–N curves were determined under fatigue loading, N being the number of cycles at which delamination begins for a given energy release rate. GICmax–a, a–N and da/dN–a curves were also determined for different Gcr rates (90%, 85%, 75%, etc.) and different test temperatures: 90 °C, 50 °C, 20 °C, 0 °C, −30 °C and −60 °C.

► In the initiation of delamination, stiffness decreases when temperature varies.
► The delamination energy required to initiate the crack increased with test temperature.
► The behaviour of AS4/3501-6 was influenced by the test temperature.
► The micrographs have a relationship with the results obtained during the tests.