Propagation of a plane-strain hydraulic fracture with a fluid lag: Early-time solution

This paper studies the propagation of a plane-strain fluid-driven fracture with a fluid lag in an elastic solid. The fracture is driven by a constant rate of injection of an incompressible viscous fluid at the fracture inlet. The leak-off of the fracturing fluid into the host solid is considered negligible. The viscous fluid flow is lagging behind an advancing fracture tip, and the resulting tip cavity is assumed to be filled at some specified low pressure with either fluid vapor (impermeable host solid) or pore-fluids infiltrating from the permeable host solid. The scaling analysis allows to reduce problem parametric space to two lumped dimensionless parameters with the meaning of the solid toughness and of the tip underpressure (difference between the specified pressure in the tip cavity and the far field confining stress). A constant lumped toughness parameter uniquely defines solution trajectory in the parametric space, while time-varying lumped tip underpressure parameter describes evolution along the trajectory. Further analysis identifies the early and large time asymptotic states of the fracture evolution as corresponding to the small and large tip underpressure solutions, respectively. The former solution is obtained numerically herein and is characterized by a maximum fluid lag (as a fraction of the crack length), while the latter corresponds to the zero-lag solution of Spence and Sharp [Spence, D.A., Sharp, P.W., 1985. Self-similar solution for elastohydrodynamic cavity flow. Proc. Roy. Soc. London, Ser. A (400), 289–313]. The self-similarity at small/large tip underpressure implies that the solution for crack length, crack opening and net fluid pressure in the fluid-filled part of the crack is a given power-law of time, while the fluid lag is a constant fraction of the increasing fracture length. Evolution of a fluid-driven fracture between the two limit states corresponds to gradual expansion of the fluid-filled region and disappearance of the fluid lag. For small solid toughness and small tip underpressure, the fracture is practically devoid of fluid, which is localized into a narrow region near the fracture inlet. Corresponding asymptotic solution on the fracture lengthscale corresponds to that of a crack loaded by a pair of point forces which magnitude is determined from the coupled hydromechanical solution in the fluid-filled region near the crack inlet. For large solid toughness, the fluid lag is vanishingly small at any underpressure and the solution is adequately approximated by the zero-lag self-similar large toughness solution at any stage of fracture evolution. The small underpressure asymptotic solutions obtained in this work are sought to provide initial condition for the propagation of fractures which are initially under plane-strain conditions.