Nanomechanical properties of wing membrane layers in the house cricket (Acheta domesticus Linnaeus)

• We did nanoindentation tests on the surface and interior layers of wing membranes.
• The Young’s moduli and hardness varied across the surface and interior.
• The Young’s moduli of the interior was higher than that of the dorsal surface.
• The hardnesses of the interior and surface layers were comparable.

Many insect wings change shape dynamically during the wingbeat cycle, and these deformations have the potential to confer energetic and aerodynamic benefits during flight. Due to the lack of musculature within the wing itself, the changing form of the wing is determined primarily by its passive response to inertial and aerodynamic forces. This response is in part controlled by the wing’s mechanical properties, which vary across the membrane to produce regions of differing stiffness. Previous studies of wing mechanical properties have largely focused on surface or bulk measurements, but this ignores the layered nature of the wing. In our work, we investigated the mechanical properties of the wings of the house cricket (Acheta domesticus) with the aim of determining differences between layers within the wing. Nanoindentation was performed on both the surface and the interior layers of cross-sectioned samples of the wing to measure the Young’s modulus and hardness of the outer- and innermost layers. The results demonstrate that the interior of the wing is stiffer than the surface, and both properties vary across the wing.

Figure optionsDownload as PowerPoint slide