کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
2912196 | 1575460 | 2013 | 7 صفحه PDF | دانلود رایگان |

ObjectivesSclerosant foams are aqueous and break down under the influence of gravity, pressure, and temperature. The aim of this study was to investigate the effects of temperature on foam stability.MethodsSodium tetradecyl sulphate (STS) and polidocanol (POL) liquid and foam (1 + 4, liquid-plus-air fraction) were investigated in a range of concentrations (0.5%, 1.5%, 3.0%) and temperatures. Surface tension was measured by the Du Nuoy ring method. Liquid drainage from foam was measured and documented by serial photography. Both pre- and post-cooling variations were investigated.ResultsSurface tension decreased at higher temperatures. Surface tension of POL was higher than STS at concentrations tested. POL foam half-time increased significantly at higher concentrations while the half-time of STS foam was not affected by concentration. Heating the sclerosant foam above the ambient temperature reduced its half-time while cooling below the ambient temperature prolonged the half-time. Both pre- and post-cooling of the foams resulted in significant prolongation of half-times when compared to no cooling. Maximum stability of the two sclerosant foams tested was achieved at 10 °C.ConclusionsFoam sclerosants are more stable at cooler temperatures.
Journal: European Journal of Vascular and Endovascular Surgery - Volume 46, Issue 5, November 2013, Pages 593–599