کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
296621 511730 2014 6 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Seismic safety evaluation based on DIP
موضوعات مرتبط
مهندسی و علوم پایه مهندسی انرژی مهندسی انرژی و فناوری های برق
پیش نمایش صفحه اول مقاله
Seismic safety evaluation based on DIP
چکیده انگلیسی

There are continuous attempts to describe the damaging potential of the seismic (or vibratory) motion by a single parameter or a set of damage indicating parameters (DIP). Recently CAV and IJMAJMI have become two very promising parameters. Originally CAV was introduced as a parameter alongside spectral characteristics of ground motion for assessment of the operational state of a nuclear power plant after a seismic event. The aim is to shorten the time for evaluation of OBE exceedance and to provide guidance for the quick restart of a seismically affected plant. Meanwhile, there has been a growing experience and confidence that the DIP could be used not only as global indicator, i.e. assessment of the severity of excitation on the plant site but also as damage descriptor at equipment level, i.e. at each equipment location. The procedure proposed is similar to that for floor response spectra generation and safety evaluation against seismically induced forces. The current paper presents basic relations between damage parameters and structural damage derived from the European strong motion database. The seismic experience database is utilized to assess the capacity/damage of equipment.A formalized approach is considered for evaluation of critical facilities subjected to dynamic vibratory loading. The following sequence of evaluation steps is discussed: Step one: for the safety equipment the standard in-structure CAV is calculated and compared with a threshold to screen-out the equipment for further considerations. An additional and optional threshold could be the in-structure IJMA intensity estimate. Step two: for all locations where standard CAV of in-structure vibrations is higher than the threshold, the floor response spectra are evaluated. They have to be compared with the equipment capacity spectra. The latter are represented by design floor response spectra multiplied by a safety factor or seismic ruggedness spectra. Step three: alternatively or simultaneously with the ultimate capacity assessment (force driven design) a displacement based evaluation of the ultimate drift capacity of the respective equipment can be performed.It has to be stressed that under high frequency excitation the displacement (drift) estimated capacity is by far more realistic than the force based estimates.If none of the above checks is positively answered detailed conventional analysis can follow; however, a much smaller amount of equipment would remain for assessment.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Nuclear Engineering and Design - Volume 269, 1 April 2014, Pages 256–261
نویسندگان
,