Numerical design of a 20 MW lead–bismuth spallation target with an injection tube

A spallation target system is a key component to be developed for an accelerator driven system (ADS). It is known that a 15–25 MW spallation target is required for a practical 1000 MWth ADS. The design of a 20 MW spallation target is very challenging because more than 60% of the beam power is deposited as heat in a small volume of the target system. In the present work, a numerical design study was performed to obtain the optimal design parameters for a 20 MW spallation target for a 1000 MWth ADS. A dual injection tube was proposed for a reduction of the lead–bismuth eutectic (LBE) flow rate at the target channel. The results of the present study show that a 30 cm wide proton beam with a uniform beam distribution should be adopted for a spallation target of a 20 MW power. When the dual LBE injection tube is employed, the LBE flow rate could be reduced by a factor of 7 without reducing the allowable beam current.