Void fraction and heat transport in two-dimensional mixed size particle beds with internal heat sources

The paper discusses the boiling heat transfer from a porous bed with internal heat sources and refers to the configuration in a nuclear reactor after a partial core melt. The flow of coolant, the temperature and the local liquid/vapor distribution were investigated in a two-dimensional configuration. Experiments were conducted using monodisperse beds as well as a mixture of two different particle sizes with a total porosity below 20%. In some tests the bed was supported by a shell of porous material to create a gap along the bottom of the test container. Water was used for tests up to 9% of the critical pressure, while other tests were made with R134a up to 44% of the critical pressure. The maximum heating rate realized inductively was 730 kW/m2. The experiments have been compared to analytical results with a one-dimensional approach.It is shown that in contrary to the situation in small cylindrical configurations the heat transfer was increased by large buoyancy driven convective flows. If there was a gap along the container bottom an additional flow of liquid improved the coolability of the bottom region even if the upper part of the particle bed was already overheated. In case of high density ratios (water at low pressure), the measurements indicated a strong enhancement of the coolant flow above a certain minimum heating rate resulting in decreasing vapor fraction values which were nearly independent of the system pressure. This was assumed to be caused by the appearance of vertical channels through which the vapor could flow through the particle bed.