Duration of elastomeric separation and effect on interproximal contact point characteristics

Introduction: The common protocol of a week-long duration of elastomeric separators to facilitate band placement usually causes discomfort. In this study, we examined the minimum separation time required to create an interproximal space >0.16 mm (band thickness), the interproximal changes over 24 hours after separator removal, and the mechanical characteristics of various separators. Methods: Thirty subjects, ages 28.1 ± 2.8 years, had an elastomeric separator placed between the mandibular second premolar and first molar (CP5-6) for 1, 4, 12, and 24 hours. After separator removal, CP5-6 was measured for space and tightness of dental contact point (TDCP) changes up to 24 hours after separator removal. The mechanical behaviors of 6 manufacturers’ separators were compared. Results: After 12 and 24 hours of separation, all patients demonstrated space >0.16 mm (P <.001). A significant negative correlation (R = –0.59 to –0.63; P = .001) was found between baseline TDCP and the space measured at separator removal. A biphasic viscoelastic recovery (82%-95%) to baseline tightness level occurred within 24 hours. Variation between manufacturers was low (9%). Conclusions: Separators should be placed a day before banding. The patient should arrive 3 to 4 hours before the appointment for separator replacement if the separator is lost. Rapid recovery after separation removal implies the biological soundness of elastomeric separation regardless of the manufacturer used.