Decreased navigated drilling time using an external guide stabilising device

SummaryIntroductionComputer navigation in orthopaedic procedures can improve accuracy and decrease radiation time compared to traditional fluoroscopy. Many different applications are now available, and drilling is commonly used amongst them. Aside from additional set up time required, the drilling procedure itself may take a significant amount of time. We hypothesised that using an external stabilising guide which can be set anywhere in space can decrease then time necessary for navigated drilling.MethodsFoam blocks, 80 mm in length and a density similar to cancellous bone, were obtained. Small discs were placed on one end as drilling targets. Using an Iso-C 3D navigation system, 20 navigated drilling trials were performed under each of two conditions: freehand, and with the use of a drill stabilising guide attached to an operating table. The time and accuracy of the two methods were compared.ResultsThe time required for the entire navigation procedure was significantly less using the stabilising arm compared to drilling freehand with navigation (4.5 min versus 5.8 min, p = 0.009). There was no significant difference in accuracy between the two methods.ConclusionUsing a guide which attaches to the table and allows the surgeon to fix the drill sleeve when the desired vector is chosen allows for faster navigated drilling. This was easy to set up and attach to the table, and did not diminish accuracy of drilling an intended target.