Biomechanical Comparison of Techniques to Reduce the Bulk of Lacerated Flexor Tendon Ends Within Digital Sheaths of the Porcine Forelimb

PurposeZone II flexor tendon repairs may create a bulging effect with increased bulk and resistance to tendon gliding. A biomechanical time 0 study was performed to assess 2 methods of tendon antibulking for work of flexion and strength characteristics.MethodsWe placed 24 fresh-frozen porcine forelimb tendons in a custom jig. Deep flexor tendon was sectioned just distal to the intact A1 and A2 pulleys. Specimens were divided into 3 groups before repair: group 1, nonmodified tendon; group 2, 30° bilateral notch excised from both tendon ends; and group 3, triangular longitudinal central wedge excised from both tendon ends. All repairs used a 4-strand modified Kessler core suture and running circumferential epitendinous suture. Work of flexion, 2-mm gap formation, and ultimate load to failure were tested.ResultsBoth antibulking techniques (groups 2 and 3) had significantly less work of flexion than group 1 (36.3 and 34.9 J vs 142.9 J, p < .001). There was no significant change in work of flexion between groups 2 and 3 (p > .05). There was no significant difference in terms of 2-mm gap formation among the 3 groups (p > .05). Groups 1 and 3 exhibited a significantly higher load to failure compared with group 2 (p < .05).ConclusionsThe antibulking repair techniques used in this study decrease the work of flexion with no significant change in force to 2-mm gap formation. Group 2, however, did have significantly lower load to failure. These techniques might be beneficial in zone II flexor tendon injury, in which the tight annular pulley system restricts tendon gliding. However, this is a time 0 study and the potential adverse effects of increase tendon manipulation and trauma were not analyzed, which might increase adhesions and scar during the healing phase of tendon repair.