Interface micromotions increase with less-conforming cementless glenoid components

BackgroundThe optimal degree of conformity between the glenoid and humeral components in total shoulder arthroplasty for best performance and durability is still a matter of debate. The main aim of this study is to evaluate the influence of joint conformity on the bone-implant interface micromotions in a cementless glenoid implant.Materials and methodsPolyethylene inlays with different degrees of conformity (radial mismatch of 0, 2, 4, and 6 mm) were mounted on a cementless metal back and then implanted in a bone substitute. These glenoid components were loaded by a prosthetic humeral head during a force-controlled experiment. Normal-to-interface micromotions and bone substitute deformations were measured at different points of the interface. Rim displacement and humeral head translation were also measured. A finite element (FE) model of the experiments was implemented to estimate the normal- and tangent-to-interface micromotions in the entire bone-implant interface.ResultsAll measured variables increased with less-conforming PE inlays. Normal-to-interface micromotions were significantly larger (P < .05) when the radial mismatch was 6 mm compared with the fully conforming inlay. The FE model was in agreement and complemented the experimental results. FE model–predicted interface micromotions were already significantly larger when the radial mismatch was equal to 4 mm.DiscussionIn a force-controlled experiment with a cementless glenoid component, a non-conforming PE inlay allows larger interface micromotions than a conforming inlay, reaching a magnitude that may hamper local bone ingrowth in this type of component. This is mainly because of the larger humeral head translation that boosts the effects of the so-called rocking-horse phenomenon.