Plateau-patella angle in evaluation of patellar height in osteoarthritis

BackgroundThe plateau-patella angle (PPA), recently introduced as a new and simpler method of measuring patellar height from the lateral radiograph, has the advantage of simplicity over previously described methods as it involves a single angular measurement without the need for calculations. The purpose of this study was to validate the use of the PPA as a measurement for patellar height in knees with moderate to severe osteoarthritis.MethodsA total of 331 patients who underwent total knee arthroplasty at our institution with radiographs prior to surgery were evaluated. Of those, 297 (89.2%) were felt to be adequate for review. Three observers with different levels of orthopedic training measured PPA, Insall–Salvati, Caton–Deschamps, and Blackburne–Peel indices on a subset of 50 consecutive patients. Interobserver agreement for each of the four measurements was calculated and correlation between each of the measurements within each observer was calculated. The measurement of the PPA was repeated. Intraobserver agreement for the PPA was determined and a normal range and distribution was defined for this population.ResultsFor the three observers, the mean PPA for the entire cohort was 25.55, 25.31, and 24.42. The intraclass correlation coefficient (ICC) was 0.81, The ICC and intraobserver assessment were the highest for the PPA compared with the other ratios. The PPA was found to correlate most strongly with the Blackburne–Peel method.ConclusionsThe plateau-patella angle is a reliable way to evaluate patellar height in the osteoarthritic population. The measurement demonstrated a higher interobserver reliability compared with previously described methods.Level of evidenceRetrospective Level IV.