کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
42737 | 45939 | 2009 | 7 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Effect of CO pretreatment on the performance of CuO/CeO2/γ-Al2O3 catalysts in CO + O2 reactions Effect of CO pretreatment on the performance of CuO/CeO2/γ-Al2O3 catalysts in CO + O2 reactions](/preview/png/42737.png)
The influence of CO pretreatment on the properties of CuO/CeO2/γ-Al2O3 catalysts was investigated using X-ray diffraction (XRD), temperature programmed reduction (TPR), X-ray photoelectron spectroscopy (XPS) and infrared spectroscopy (IR). The activities of the treated catalysts were measured in low-temperature CO oxidation reactions (≤200 °C). For this reaction, the activities of CuO/CeO2/γ-Al2O3 catalysts are intimately related to operation temperature, copper oxide loading amount and CO pretreatment. The influence of the first two factors, i.e., operation temperature and copper oxide loading amount, is similar to the previous results of CuO/γ-Al2O3 catalysts [H.Q. Wan, Z. Wang, J. Zhu, X.W. Li, B. Liu, F. Gao, L. Dong, Y. Chen, Appl. Catal. B: Environ. 79 (2008) 254–261]. CO conversions are clearly promoted with increasing operation temperatures and the maximum CO conversions are always reached over the catalysts with a copper oxide loading amount of 0.6 mmol Cu2+/100 m2 γ-Al2O3, at the set operation temperatures. For the third factor, CO conversions over the CO-treated CuO/CeO2/γ-Al2O3 catalysts are slightly lower than those over the fresh catalysts with the same amount of copper oxide. In contrast, the activity was enhanced over the CO-treated CuO/γ-Al2O3 catalysts in the previous report. XRD, TPR and XPS results show that CO pretreatment at 250 °C mainly results in the reduction of crystalline CuO to Cu0 and of partially dispersed Cu2+ to Cu+ and Cu0 in CuO/CeO2/γ-Al2O3 catalysts. IR results indicate that besides the CO–Cu+ adsorption band at ∼2110 cm−1 on the fresh and CO-pretreated catalysts exposed to CO stream when temperatures are above 50 °C, a new adsorption band at 2170 cm−1 is detectable corresponding to CO–Cu2+ or CO–Cu0 over the CO-treated CuO/CeO2/γ-Al2O3 catalysts with copper oxide loading amounts of 0.3 and 1.2 mmol/100 m2γ-Al2O3 at the adsorption temperatures beyond 150 °C. The influences of the ceria modification on the generation of copper species in fresh and CO-treated CuO/CeO2/γ-Al2O3 catalysts and their activities in CO oxidation were discussed.
The influence of CO pretreatment on the properties of CuO/CeO2/γ-Al2O3 catalysts was investigated by XRD, H2-TPR and IR, and the activities of the catalysts in low-temperature CO oxidation reactions were tested. The results indicate that CO treatment leads to the decrease of the activity of CuO/CeO2/γ-Al2O3 catalysts while such treatment causes an increase of the activity of the CuO/γ-Al2O3 catalysts in low-temperature CO oxidation (≤200 °C).Figure optionsDownload as PowerPoint slide
Journal: Applied Catalysis A: General - Volume 360, Issue 1, 31 May 2009, Pages 26–32