Improvement of sampling plans for Salmonella detection in pooled table eggs by use of real-time PCR

• The sensitivity of sampling plan for Salmonella detection on table eggs was studied.
• Sample size, number of sample units and analytical method might affect sensitivity.
• ISO 6579 and Real-Time PCR were applied on Salmonella spiked eggshell pools.
• The analytical method affects sensitivity, pooling does not.
• At least 16 pools are needed to be tested by ISO 6579. By applying Real-Time PCR only 8 pools are required.

Eggs and egg products have been described as the most critical food vehicles of salmonellosis. The prevalence and level of contamination of Salmonella on table eggs are low, which severely affects the sensitivity of sampling plans applied voluntarily in some European countries, where one to five pools of 10 eggs are tested by the culture based reference method ISO 6579:2004. In the current study we have compared the testing-sensitivity of the reference culture method ISO 6579:2004 and an alternative real-time PCR method on Salmonella contaminated egg-pool of different sizes (4–9 uninfected eggs mixed with one contaminated egg) and contamination levels (10°–101, 101–102, 102–103 CFU/eggshell). Two hundred and seventy samples corresponding to 15 replicates per pool size and inoculum level were tested. At the lowest contamination level real-time PCR detected Salmonella in 40% of contaminated pools vs 12% using ISO 6579. The results were used to estimate the lowest number of sample units needed to be tested in order to have a 95% certainty not falsely to accept a contaminated lot by Monte Carlo simulation. According to this simulation, at least 16 pools of 10 eggs each are needed to be tested by ISO 6579 in order to obtain this confidence level, while the minimum number of pools to be tested was reduced to 8 pools of 9 eggs each, when real-time PCR was applied as analytical method. This result underlines the importance of including analytical methods with higher sensitivity in order to improve the efficiency of sampling and reduce the number of samples to be tested.