Estimation of roughness lengths and flow separation over compound bedforms in a natural-tidal inlet

• Velocity profiles collected over tidal compound bedforms were analysed.
• Flow separation zone over bedform lee side was identified.
• Ebb profiles showed the influence of both secondary and primary bedform roughness.
• Flood profiles were dominated by the secondary bedform roughness.
• Primary bedform roughness is related to flow separation (ebb only).

The hydraulic effect of asymmetric compound bedforms on tidal currents was assessed from field measurements of flow velocity in the Knudedyb tidal inlet, Denmark. Large asymmetric bedforms with smaller superimposed ones are a common feature of sandy shallow water environments and are known to act as hydraulic roughness elements in dependence with flow direction. The presence of a flow separation zone on the bedform lee was estimated through analysis of the measured velocity directions and the calculation of the flow separation line. The Law of the Wall was used to calculate roughness lengths and shear velocities from log–linear segments sought on transect-averaged and single-location velocity profiles. During the ebb tide a permanent flow separation zone was established over the steep (10–20°) lee sides of the ebb-oriented primary bedforms, which generated a consequent drag on the flow. During the flood, no flow separation was induced by the gentle (2°) lee side of the primary bedforms except over the steepest (10°) part of the lee side where a small separation zone was sometimes observed. As a result, hydraulic roughness was only due to the superimposed bedforms. The parameterized flow separation line was found to underestimate the length of the flow separation zone of the primary bedforms. A better estimation of the presence and shape of the flow separation zone over complex bedforms in a tidal environment still needs to be determined; in particular the relationship between flow separation zone and bedform geometry (asymmetry, relative height or slope of the lee side) is unclear. This would improve the prediction of complex bedform roughness in tidal flows.