کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
4912883 1428749 2017 10 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Use of calcium sulfoaluminate cements for setting control of 3D-printing mortars
موضوعات مرتبط
مهندسی و علوم پایه سایر رشته های مهندسی مهندسی عمران و سازه
پیش نمایش صفحه اول مقاله
Use of calcium sulfoaluminate cements for setting control of 3D-printing mortars
چکیده انگلیسی
Printing cementitious structures in 3D (3D Printing) requires the use of a mortar which setting is rigorously controlled. In this paper, a mix made out of two types of cement, ordinary Portland cement (OPC) and Calcium Sulfo-aluminate cement (CSA), was adopted to control the printability of a mortar. The latter was formulated in order to be extrudable, buildable and to reach a compressive strength comparable to that of a traditional mortar. Finally, a printable mix made out of 7% CSA and 93% OPC was developed. The cement paste of the developed mix was tested using isothermal calorimetry to study the impact of CSA on the heat of hydration of the mix. The mortar is first checked for the two characteristics of printability (extrudability and buildability) by a manual home-made device. Then, an estimation of the rheological properties of the mortar using a penetration test was done. Afterwards, the strength of the mortar was tested and a compressive strength of 88 MPa was found after 28 days for non-printed specimens and 79 MPa for printed specimens.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Construction and Building Materials - Volume 157, 30 December 2017, Pages 382-391
نویسندگان
, , , ,