Pebble fabrication and tritium release properties of an advanced tritium breeder

Li2TiO3 with excess Li (Li2+xTiO3+y) has been developed as an advanced tritium breeder. With respect to the tritium release characteristics of the blanket, the optimum grain size after sintering was less than 5 μm. Therefore, an emulsion method was developed to fabricate pebbles with this target grain size. The predominant factor affecting grain growth was assumed to be the presence of binder in the gel particles; this remaining binder was hypothesized to react with the excess Li, thereby generating Li2CO3, which promotes grain growth. To inhibit the generation of Li2CO3, calcined Li2+xTiO3+y pebbles were sintered under vacuum and subsequently under a 1% H2-He atmosphere. The average grain size of the sintered Li2+xTiO3+y pebbles was less than 5 μm. Furthermore, the tritium release properties of Li2+xTiO3+y pebbles were evaluated, and deuterium-tritium (DT) neutron irradiation experiments were performed at the Fusion Neutronics Source facility in the Japan Atomic Energy Agency. To remove the tritium produced by neutron irradiation, 1% H2-He purge gas was passed through the Li2+xTiO3+y pebbles. The Li2+xTiO3+y pebbles exhibited good tritium release properties, similar to those of Li2TiO3 pebbles. In particular, the released amount of tritiated hydrogen gas for easier tritium handling was greater than the released amount of tritiated water.