Modification of three dimensional topography of the machined KDP crystal surface using wavelet analysis method

The wavelet analysis method has been extensively employed to analyze the surface structures and evaluate the surface roughness. In this work, however, the wavelet analysis method was introduced to decompose and reconstruct the sampled surface profile signals in the cutting direction that achieved by SPDT (single point diamond turning) operation, and the surface profile signals in tool feeding direction were reconstructed with the approximate harmonic functions directly. And moreover, the orthogonal design method, i.e. the combination design of general rotary method, was resorted to model the variations of the independent frequency and amplitude of different simulated harmonic signals in the cutting and tool feeding directions. As expected resultantly, a novel 3D surface topography modeling solution was established, which aims to predict and modify the finished KDP (potassium dihydrogen phosphate or KH2PO4) crystal surfaces. The validation tests were carried out finally under different cutting conditions, and the collected average surface roughness in any case was compared with the corresponding value as predicted. The results indicated the experimental data were well consistent with the predictions, and only an average relative error of 11.4% occurred in predicting the average surface roughness.