کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
5369061 | 1388419 | 2009 | 5 صفحه PDF | دانلود رایگان |

This article describes a new technique for fabricating an electrocatalyst model in which the particle size and interparticle distance are controlled independently. We designed a uniform insulating polymer layer as a mask on an electroconductive glassy carbon substrate and then peeled off a part of the layer in nano-sized dots by scratching the overcoat layer using an atomic force microscope (AFM) cantilever. Pt particles electrodeposited only on the peeled off area of the glassy carbon. To peel-off a small area on the glassy carbon, a 29 ± 2 nm thick insulating polymer overcoat layer and a cantilever operating area of 10 nm Ã 10 nm were used, and the smallest peel-off area obtained was 30 nm Ã 30 nm. Thereafter, we performed the peel-off procedure on the polymer overcoat layer of the glassy carbon substrate having a cantilever operating area of 80 nm Ã 80 nm. Pt deposition of 100-150 nm in diameter was successfully achieved by adjusting the interparticle distance.
Journal: Applied Surface Science - Volume 255, Issue 22, 30 August 2009, Pages 9154-9158