Structure of the hydroxyapatite plasma-sprayed coatings deposited on pre-heated titanium substrates

Plasma spraying is the most commonly used thermal spray method for the application of hydroxyapatite (HA, Ca10(PO4)6(OH)2) coatings. In the present study, the HA coatings were plasma spraying deposited onto plates of titanium pre-heated to 20 °C, 300 °C and 550 °C. The obtained HA coatings were investigated by means of X-ray diffraction and scanning electron microscopy. It is found that the coatings, in addition to HA, contain the tetracalcium phosphate (TTCP, (Ca4(PO4)2O) phase (~10%) and a small amount of CaO (<2%). Crystal structure of HA in the coatings is revealed to be distorted. The PO4 tetrahedrons are deformed (Baur distortion coefficient D1(TO) ~0.2). The distances Ca1-O1 and Ca1-O2 are changed as compared to these in stoichiometric hydroxyapatite. These distortions are considered as a result of internal stresses, which are demonstrated in the broadening of peaks on X-ray diffraction pattern of HA. Microstructure of coatings consisting of flattened splats was formed by fully molten particles. The axial base texture was developed in the coatings. Ultrastructure is columnar with a preferred orientation of c-axes of the crystals parallel to the normal of plane coating n. The heating of substrate has a marked effect on the ultrastructure of coatings: the domain size increases from 790 to 1100 Å, the strain Δ decreases from 1.6·10-3 to 1,2·10-3, TTCP content diminishes from 12% to 7%. These results show that the effects due to heating of the substrate may be associated with partial recovery of HA microstructure.