Leak-Before-Break assessment of a welded piping based on 3D finite element method

The paper studies the effects of the load reduction (discrepancy between designing and real loadings), strength match of the welded piping joint (WPJ), welding width, crack size and crack tip constraint on the Leak-Before-Break (LBB) assessment of a welded piping. The 3D finite element (FE) method is used in the study of a surge line of the steam generator in a nuclear power plant. It is demonstrated that the LBB margin is dependent on the loading level and the load reduction effect should be considered. When the loading is high enough, there is a quite large deviation between the J-integral calculated based on the real material property of WPJ and that calculated based on the engineering method, e.g. Zahoor handbook of Electric Power Research Institute (EPRI). The engineering method assumes that the whole piping is made of the unique welding material in the calculation. As the influence of the strength matching and welding width is ignored in the engineering method for J-integral calculation, the engineering method has a sufficient precision only if the width of welding is comparable to the crack depth. Narrower welding width leads to higher constraint of the plastic deformation in the welding and larger high stress areas in the base for the low strength-match WPJ. Higher strength matching of WPJs has higher crack-front constraints.