Suppression of cone discharges in a powder silo using a grounded metal rod

While filling a large silo with coarse nonconductive powders, strong electrostatic sparks known as a cone discharge, which can become sufficiently energized to ignite a flammable dust cloud, often occur on the surface of a powder heap. In an attempt to mitigate or eliminate a cone discharge, a long metal rod with a pointed tip or a flat tip was vertically installed in the center of an experimental silo (1.5 m in diameter, 2 m in effective height) with the objective that the static charge might be released by the corona discharges or the surface potential of the powder heap reduced by the electric field reducing effect. The experimental results are summarized as follows:(1) No cone discharges were observed while the silo was being filled with polypropylene pellets when either a pointed tip or a flat-tip rod was installed so that its lower end was located 10 cm above or 30 cm below the heap surface level. A corona discharge that occurred on the pointed tip was shown to be effective to some extent in reducing the charge of the powder heap.(2) Brush discharges were observed near the metal rod and its support. However, we assume that the maximum energy was not high enough to ignite a dust cloud with minimum ignition energy greater than 3 mJ.